海角社区

important

Note: This is the 2022鈥2023 eCalendar. Update the year in your browser's URL bar for the most recent version of this page, or .

Grading and Grade Point Averages (GPA)

Grading and Grade Point Averages (GPA)

Note for Physical and Occupational Therapy: A grade of C+ is a minimum required passing grade for courses with the subject codes of OCC1, PHTH, and POTH. A grade of C is a minimum required passing grade for all other courses. For complete details, refer to the Rules and Regulations, available at mcgill.ca/spot/programs.

Instructors may submit final grades as either letter grades or in percentages, but the official grade in each course, which displays on the transcript is the letter grade. Where appropriate, a class average appears on transcripts expressed as the letter grade most representative of the class performance. In such cases, the class average is calculated for courses, where the total number of grades in all of its course sections is 25 or more, and the grades have a grade point (e.g. grades of S, U, or P do not have grade points).

Since Fall 2002, the University has only used letter grades on transcripts and verification forms.

Grades A through C represent satisfactory passes, D a conditional (non-continuation) pass, and F a failure. Certain courses have been approved for Pass/Fail (P/F) grading. Students may also designate elective courses to be graded under the S/U option. See Courses Taken under the Satisfactory/Unsatisfactory (S/U) Option.

Policy on Pass/Fail Grading:

For a course to be graded P/F, a proposal must be approved by the Program Director, approved by the Faculty Curriculum Committee, and approved by the Subcommittee on Courses and Teaching Programs (SCTP). Courses that are approved to be graded P/F must indicate this in the course syllabus. Pass/Fail grading applies to all students in a course section and cannot be selectively added to individual students.

Grades of Pass are not included in the GPA calculation and as such are not normally applied to required courses. Grades of F are included in GPA calculations. However, both grades of P and F are included in the count of completed credits for determining eligibility for scholarships and awards.

Please refer to the Satisfactory/Unsatisfactory option for information on that grading option for students.

You must obtain a grade of C or better in courses that you take to fulfil program requirements. You may not register in a course unless you have passed all the prerequisite courses with a grade of C or better, except by written permission of the appropriate department chair.

Grades Grade Points Numerical Scale of Grades
A 4.0 85 鈥 100%
A- 3.7 80 鈥 84%
B+ 3.3 75 鈥 79%
B 3.0 70 鈥 74%
B- 2.7 65 鈥 69%
C+ 2.3 60 鈥 64%
C 2.0 55 鈥 59%
D 1.0 50 鈥 54%
F (Fail) 0 0 鈥 49%
Note for Engineering: The Faculty of Engineering does not use this numeric scale. See Note for Engineering below.
Note for Law: Faculty of Law does not use this numeric scale.

The University assigns grade points to letter grades according to the table above. Your Academic Standing (e.g. satisfactory, probationary), which is your academic status at the end of each term, is determined by a grade point average (GPA), which is calculated by multiplying the course credit by the grade points, and dividing the sum by the total course GPA credits. The GPA result is truncated by two decimal points and not rounded up to the nearest decimal point. For example, a GPA of 3.596 will display on the transcript as 3.59 and is NOT rounded up to 3.60.

GPA credits are the credits of courses with grades that are assigned grade points.

The term grade point average (TGPA) is the GPA for a given term calculated using all the applicable courses at the same level in that term. The cumulative grade point average (CGPA) is the GPA calculated using your entire record of applicable courses at 海角社区 at the same level; if you change levels, e.g., from undergraduate to graduate, the CGPA starts again.

This policy took effect in January 2003. Prior to January 2003, if your degree program had changed鈥攅.g., from B.Sc. to B.A.鈥攖he CGPA calculation restarted again. For students with academic information prior to Fall 2002, who are registered in a different program or in a different level post-Fall 2002, the transcript displays a special message regarding the CGPA restarting.

If you repeat courses, all final grades are included in the GPA calculation. Therefore, grades of D or F continue to be used in the CGPA calculation even after you repeat the course or if you take a supplemental examination. Note that credits are only granted once for a repeated course regardless of the passing grade.

You must obtain a minimum CGPA of 2.00 to be considered for graduation with a 海角社区 degree.

Note: During the first week of lectures, each instructor will provide you with a written course outline. This information should include, where appropriate:
  • whether there will be a final examination in the course;
  • how term work will affect the final grade in the course;
  • how term work will be distributed through the term;
  • whether there will be a supplemental examination in the course, and if so, whether the supplemental exam will be worth 100% of the supplemental grade, or whether term work will be included in the supplemental grade (courses with formal final examinations must have supplementals);
  • whether students with grades of D, F, J, or U will have the option of submitting additional work, and, if so, how the supplemental grade will be calculated with the extra work (applicable only to students in Science and B.A. & Sc.).
Note for Engineering: In the Faculty of Engineering, letter grades are assigned according to the grading scheme adopted by the professor in charge of a particular course. This may not correspond to grades indicated in the 鈥淣umerical Scale of Grades鈥 column in Grading and Grade Point Averages. A grade of D indicates marginal performance which is acceptable only for Complementary Studies courses (i.e., Group A Impact of Technology on Society; and Group B Humanities and Social Sciences, Management Studies and Law), Natural Science Complementary Courses (for Computer Engineering and Software Engineering students from CEGEP), and Elective Courses (for Mechanical Engineering students from CEGEP and for Architecture students). A grade of D is not acceptable for required (core) courses (including Year 0 (Freshman) math and science courses), technical complementary courses, laboratory complementary courses, or courses in any other category of the Engineering programs. Individual departments/schools will decide if a student with a D in a prerequisite course(s) may take the subsequent course.
Grades have the following designations:
A, A- Very Good
B+, B, B- Good
C+, C Satisfactory
D Conditional Pass
F Fail
Programs, Courses and University Regulations—2022-2023 (last updated Jan. 26, 2023) (disclaimer)

Grading and Grade Point Averages (GPA): Other Grades

Grading and Grade Point Averages (GPA): Other Grades

Note: Not all grades listed below apply to every faculty, school or level. Faculty policy prevails when determining if a student may be eligible to receive one of these grades.
Other Grades

J

unexcused absence (failed); the student is registered for a course but does not write the final examination or do other required work; calculated as a failure in the TGPA and CGPA

K

incomplete; instructor has extended the deadline for submission of work in a course

KE or K*

further extension granted for submission of work in a course, approval from the Faculty SAO may be required

KF

failed to meet the extended deadline for submission of work in a course; calculated as a failure in TGPA and CGPA

KK

completion requirement waived; not calculated in TGPA or CGPA; Associate Dean approval is required.

L

approved to write a deferred examination in a course

LE or L*

permitted to defer examination for more than the normal period

NR

no grade reported by the instructor (recorded by the Registrar)

P

pass; not calculated in TGPA or CGPA

Q

course continued in next term (applicable only to courses taken pre-Fall 2002)

S

satisfactory; equivalent to C or better in an elective course; not calculated in TGPA or CGPA (See Courses Taken under the Satisfactory/Unsatisfactory (S/U) Option)

U

unsatisfactory; equivalent to D or F in an elective course; not calculated in TGPA or CGPA (See Courses Taken under the Satisfactory/Unsatisfactory (S/U) Option)

W

withdrew; a course dropped, with permission, after the Course Change deadline; not calculated in TGPA or CGPA

WF

withdrew failing; a course dropped, with special permission in an exceptional case, after faculty deadline for withdrawal from course, the student's performance in the course at that stage being on the level of an F; not calculated in TGPA or CGPA (Not used by Music.)

WL

faculty permission to withdraw from a deferred examination; not calculated in TGPA or CGPA

NA or &&

grade not yet available

W- - or - -

no grade; student withdrew from the University, not calculated in TGPA or CGPA (applicable only to courses taken pre-Fall 2002)

Note for Physical and Occupational Therapy: Grades of S/U are not applicable.
Programs, Courses and University Regulations—2022-2023 (last updated Jan. 26, 2023) (disclaimer)

Unexcused Absences

Grading and Grade Point Averages (GPA): Unexcused Absences

All students who miss a final exam or do not complete other final work in a course are given a J grade. You then have the following options:

  1. Ask to be assigned a grade based only on the grades earned for your work submitted up to, but not including, the final exam or final course work.

    The grade earned is calculated by adding the grades obtained on the individual pieces of work and a grade of 0 for the portion of the final grade allocated to the final exam or final course work. This option is not available if the professor stipulated in the course outline that the final exam is a required part of the evaluation.

  2. Request a deferred exam, if you have the appropriate reasons and documentation.
  3. Apply for a supplemental exam if permitted by your faculty.
Note for Engineering: Option 1 is not available to students in the Faculty of Engineering.
Note for Law: Option 1 is not available to students in the Faculty of Law. Option 3 is by approval of the Associate Dean (Academic) or the Director (Student Life & Learning) only.
Note for Music: Option 1 is not available to students in the Schulich School of Music.

You must request option 1 no later than four months after the end of the examination period of the original course.

You must request option 2 by the faculty deadlines as indicated in University Regulations & Resources > Undergraduate > Examinations: General Information > Final Examinations > Final Examinations: Deferred Examinations.

You must request option 3 by the faculty deadlines as indicated at mcgill.ca/exams.

If you wish to appeal a J grade, you should write to your Associate Dean or Director.

Note for the Faculties of Arts and Science (including B.A. & Sc.): Requests are made at Service Point (3415 McTavish Street). However, it is important that you also see a Faculty adviser in Arts OASIS or SOUSA to talk about your options and the effects that your request may have on your studies. For more information, see mcgill.ca/students/advising.
Note for Graduate and Postdoctoral Studies: Only options 2 and 3 above are applicable to graduate students. Students wishing to appeal a J grade should write to the Associate Registrar, Management of Academic Records.
Programs, Courses and University Regulations—2022-2023 (last updated Jan. 26, 2023) (disclaimer)
Programs, Courses and University Regulations—2022-2023 (last updated Jan. 26, 2023) (disclaimer)
Back to top